Saw with back side of the siding towards saw

Step 5:

To reduce feathering, it is advisable to cut from the backside of the board.  This also allows you to cover up the pencil marks. 

End grain with feathering on back side

Step 6:

While pine, spruce and other siding cuts cleanly, cedar tends to feather somewhat after sawing.

"Split-less" nails are best

Step 7:

Correct nail selection is critical to:  reduce splitting, provide holding action and resist corrosion. Here, we are using 8d (2 1/2") "split-less" nails.  The ring shanks help to keep the nails from pulling back out.

Corner alignment

Step 8:

After finishing one wall, be sure to make a good corner alignment. The ends of each board should be straight and parallel.  Note in this application that the bottom board on the porch was ripped first to ensure the alignment.

1 - 2

Printer friendly page

E-mail this page to a friend

Please note:  We consider all of the information on this site to be reliable.   We strive to provide the best home improvement and repair content possible, but we assume no liability for the information contained herein. [Full Disclaimer]  
All information contained is © Copyright 2000 - InsideSpaces.com, Inc.           Click here to read our privacy statement.